40W Eleaf iStick TC Kit with GS TC Atomizer, is the innovative temperature control iStick from Eleaf. Both TC-Ni and regular VW mode available. It comes with GS airflow control atomizer and ni 0.15ohm coil.
Warning: Last items in stock!
40W Eleaf iStick TC Kit with GS TC Atomizer, is the innovative temperature control iStick from Eleaf. Both TC-Ni and regular VW mode available with max 40W output. It comes with GS airflow control atomizer, ni 0.15ohm coil pre-installed.
40W istick battery:
Battery size: 21*35*82mm
Wattage output: 5-40W
Max output voltage: 8V
Minimum resistance: 0.05ohm(VT mode), 0.15ohm(VW mode)
Temperature range: VT mode 200~600 F or 100~310℃
GS TC tank:
Size: 22.1 x 49.8mm
40W Eleaf iStick TC Kit comes with
Temperature control, Max 40w output
TC-Ni/regular VW mode
High capacity and stability li-battery
Pure cotton wick with TC Ni heating wire
Stainless steel threads and spring connector
Attached necklace hole
Clear OLED display
Power on/off: press the fire button five times in quick succession to turn it on. In the same way, it can be turned off.
Vaping: long press the fire button to take a puff.
Stealth on/off: press the fire button and down button simultaneously when the battery is on to switch between Stealth on and Stealth off mode. In the Stealth on mode, you can vape with the OLED screen off and you can press the fire button one time to see current setting.
Switch display mode: keep pressing up and down button simultaneously for two seconds when the battery if off, the screen display will rotate 180 degrees.
Shift between TC-Ni and VW modes: long press the menu button to shift modes.
How to charge: The battery power indicator on the screen will keep flashing when the remaining power is less than 10%. It can be charged with the USB cable through the USB port at the bottom. It will take about 3.5 hours to get a full charge via 1A wall adapter.
How to add liquid: Screw the base off GS atomizer firstly; Slowly refill the liquid into the two small holes along the tube. Pay attention don't add liquid into the air pipe and do not overfill, leave a small air pocket in order to avoid leakage.